Take Offs - top, center or bottom aligned

Take Offs - top, center or bottom aligned

FabricAir can produce duct take-offs in top, center, or bottom aligned configuration. Typically we produce a top aligned take-off due to the installation advantages of this method. If you want a different configuration we will produce to the alignment that suits your need as part of our standard offer.

FabricAir can make concentric or eccentric reducers in any taper ratios desired. 

FabricAir elbows are produced on demand. We can make the standard 22.5°, 45° and 90° or any angle in between, as we tailor the system to your specific needs. 

FabricAir can manufacture straight sections of duct in any diameter as long or as short as you want them preffered.

FabricAir dispersion systems do not have limitations when it comes to elbows, reducers and take-offs, such as conventional metal ducting does.