Reducers - concentric or eccentric

Reducers - concentric or eccentric

FabricAir can make concentric or eccentric reducers in any taper ratios desired. Typically we will produce an eccentric reduction in the top aligned configuration, due to the installation advantages of this method. If you want a different configuration the taper ratio or alignment is changed as part of our standard offer.

FabricAir elbows are produced on demand. We can make the standard 22.5°, 45° and 90° or any angle in between, as we tailor the system to your specific needs. 

FabricAir can manufacture straight sections of duct in any diameter as long or as short as you want them preffered.

FabricAir can produce duct take-offs in top, center, or bottom aligned configuration. 

FabricAir dispersion systems do not have limitations when it comes to elbows, reducers and take-offs, such as conventional metal ducting does.